Weboost Connect 4G-X | 471104

After the success from its AG Pro lineup in 3G speeds, Weboost wanted to replicate the same in the 4G division and has come out with this AG pro Quint unit. Now, this booster system can boost signal for all carriers including AT&T, T-Mobile, and Verizon. The gamut of frequency it boosts runs from 700 mHz on AT&T, 700 mHz on Verizon, 800 mHz cellular, 1900 mHz PCS, to 1700/2100 mHz. Our complete kit includes the AG Pro Quint amplifier, 2 x 50 ft low loss cable, indoor antenna, outdoor antenna, necessary hardware to perform a complete home installation.

Overview

  • Most affordable 5 band unit in the market boosts signal on 800 mHz, 1900 mHz, AWS, and 4G LTE networks
  • Works with CDMA, GSM, EVDO, LTE, HSPA+, and WCDMA technologies, which basically means this kit will work on any phone and any network within continental United States.
  • Boost cell phone signal for up to 10,000 Sq ft building
  • Boosts cell phone and data signal on all bands of cell phone operation
  • Weights less than 3 lbs and whole unit is enclosed in a metal case
  • Has the stamp of approval from FCC to protect cell sites

Kit Includes

  • Weboost connect 4G-X amplifier
  • Wide band yagi antenna for outdoor – 301213
  • Indoor ceiling mount dome or wall mount panel antenna – 301135
  • 2 x 50 ft LMR low loss cables

Note: A second indoor antenna can be added to this kit if you choose to split the amplified signal into two separate floors or sections inside any buildings. Optional add on kit with a second antenna, 2-way splitter and 50ft cable can be added at checkout!

pdfDownload Installation Manual

Connection Diagram

weboost connect 4g-x installation

Table Specification

Model Number
471104
Antenna Connectors
N-Female
Antenna Impedance
50 Ohms
Dimensions
8.875 x 6.0 x 1.5 in. (22.5 x 15.2 x 3.8 cm)
Weight
2.8 lbs (1.270 kg)
Frequency
698-746 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz,
1710-1755/2110-2155 MHz
Power output for a
single phone dBm
700 MHz
Band 12
700 MHz
Band 13
800 MHz
1900 MHz
1700/2100 MHz
Uplink
23.2
23.8
25.2
22.1
22.5
Downlink
-0.4
-2.1
-2.0
-1.4
0.9
Noise Figure
(typical downlink/uplink)
7 dB nominal
Isolation
> 90 dB
Power Requirements
110-240 V AC, 50-60 Hz, 20 W

 

This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approv3ed antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards.

Leave a Reply