TriFlex2Go 4G Vehicle Kit- SCTri50KIT

The Triflex2Go is the strongest and most powerful 4G kit designed for multiple users inside vehicles. Whether you are a using your phone as GPS or the kids streaming videos on their iPad, this repeater kit has the infrastructure to support and sustain such demands.

Key Features

  • 50 dB linear gain for fast 4G data and 3G voice
  • Individual tuner lets you fine tune the bandwidth you desire
  • Boost 2G, 3G voice and data on all carriers including AT&T, Verizon, T-Mobile, Sprint
  • 4G data boost is carrier specific, so choose the carrier you like to boost at the checkout
  • Hard metal casing is heat and cold resistant to operate this device in extreme temperatures when driver not inside the vehicle
  • Wireless signal for multiple user and device operation

    • Kit Includes

    • 50 dB gain booster unit – TriFLEX2GO
    • 13″ high magnet mount antenna with 10 feet cable – CM200
    • Slim indoor patch antenna that literally disappears inside the car – CM110
    • DC adapter with 6 feet cable with Velcro™ and mounting screws
    • Approved by FCC and all US carriers for operation

    Installation

    The magnet mount antenna for outside is a snap on the roof of the vehicle and the cigarette light adapter is a push and the N-type male connector on the cable is a screw, that is all! No pairing of the phone or time consuming software installation. Just plug and you are ready to roll.

    Specification

    Frequency Uplink: 824-849/1850-1910/776-787 MHz. Downlink : 869-894/1930-1990/ 746-757 MHz.
    Input Impedance 50 ohm
    Average Gain 50dB Cellullar / 50dB PCS / 50 dB LTE
    Maximum Gain 50dB
    VSWR <2.0
    Standard Supported CDMA / WCDMA,GSM,EDGE, HSPA+, EVDO, LTE and all other cellular standards
    AC Power Transformer Input AC110V,60Hz; Output DC 5-15V
    DC Power 5-15V
    Maximum RF Output Power 1 Watt EIRP
    Noise Figure 5dB
    Cable CM174 and CM240 recommended
    RF connectors FME Male Connectors on both ends
    Power Consumption <9W
    Dimensions 9.25" x 6.25" x 1.5"
    Weight 3 lb 8 oz


    This is a CONSUMER device.
    BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approv3ed antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
    WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards.

    Leave a Reply