Dual Force 72 dB 3G,1-Way |980072

If you want to boost 3G signal inside buildings to cover up to 50,000 sq ft, this Surecall Dual Force packs a punch with 72 dB gain. This industrial strength aluminum cased booster can handle 50 users simultaneously. This system is scalable and adding more indoor antennas when needed makes it ideal for a growing manufacturing, factory, or office facility.

Key Features

  • 72dB PCS/ 72dB Cellular dual force amplifier with independent gain control
  • Smart Processor gain control for linear gain and automatic gain control
  • Completely eliminates interference and approved by the FCC
  • Stealth technology ensures that the system remain in sleep mode when not in use
  • 30 day risk free trial guarantee
  • Works for all phones and all carriers including T-Mobile, Verizon, AT&T, Sprint PCS, Alltel, Cricket, Metro PCS, US cellular, Tracfone, Boost Mobile, Virgin Mobile, with the exception of Nextel
  • Increases data connection speed for smart phones and surfing the web
  • Low temperature casing for low operating temperature

Networks Supported

  • AT&T 2G/3G/4G voice+ data
  • Verizon 2G/3G/4G HSPA & LTE voice+ data
  • Sprint 2G/3G/4G voice+ data
  • US Cellular 2G/3G/4G voice+ data
  • Alltel 2G/3G/4G voice+ data
  • T-Mobile 2G/3G/4G HSPS & LTE voice+ data
  • Major Canadian Carriers 2G/3G/4G voice+ data
  • All other carriers using 698-746 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz,1710-1755/2110-2155 MHz

What’s Included

  • Dual Force 80dB dual band amplifier
  • Highly sensitive outdoor yagi antenna
  • Omnidirectional dome antenna for indoor boradcast
  • 75ft and 30 ft low loss LMR400 coaxial cable
  • Necessary hardware for antenna installation, (pole for outdoor mount not provided).Instruction Manual
    Dual Force Installation Diagram For Reference

    Technical Specifications

    Frequency range Uplink: 824-849 and 1850-1910 MHz
    Downlink: 869-894 and 1930-1990 MHz
    Standard supported

    CDMA, WCDMA, GSM, EDGE, TDMA and AMPS etc.
    Gains

    Celluar 65dB / PCS 65dB
    Maximum output power

    3 Watts EIRP
    Impedance 50 ohms
    Noise figure Maximum 5 dB
    VSWR Less than 2:1
    AC power transformer Input: AC110V, 60Hz; Output: DC 6V
    Cable
    LMR400 or CM400 recommended
    RF connectors N female connectors on both ends
    Power consumption <10W

    Operating temperature

    -20° to +70°C

    Dimension
    7 x 4.8 x 1.2 inch3

    Weight

    1.5LB

    This is a CONSUMER device.
    BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approv3ed antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
    WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards.

Leave a Reply