Weboost Connect 3G-Yagi | 472205

This 65 dB gain “Weboost Connect 3G-Yagi” kit increases the signal strength on all Cellular and PCS band width. The outdoor Yagi antenna in this kit does an excellent job capturing the weakest cell signal and transmitting it to the amplifier. The award winning DB Pro Weboost amplifier does the rest. This kit eliminates dead zone, dropped calls and slow internet connection inside any type of metal, brick or shielded buildings .

Key Features

  • Strengthens signal for multiple cell phones, data cards, tablets and any other device that works on cell phone signal.
  • Requires no set-up of any kind, just plug the device to the power supply and watch your bars raise
  • Another important feature about this unit is that it uses RG6 cable for connection. If you already have a RG6 TV cable wired into your building, the installation can be done on the same.
  • 250 milliwatts max output power is 12 times stronger than a typical cell phone output
  • Adjustable gain for each frequency, makes the installation easy with no feedback problems
  • Works with all technologies like CDMA, GSM, and 3G data
  • Multiple carriers and multiple users can use the signal simultaneously
  • Your communication is safe and secure, since the booster operates in the same frequency as your cell phone provider, unlike Femtocells where signal goes through the internet
  • FCC approved amplifiers and antennas require no setup or software installation. Just power up and see your signal raise
  • 2 year manufactures warranty
  • 30 day risk-free trial guarantee

What’s Included

All the components you require to install a complete system are included, listed as below:

  • 65 dB gain Weboost amplifier- 472005
  • Directional yagi external antenna – 314475
  • Internal panel antenna or dome antenna – 311155
  • 2 x 30ft RG6 ultra low loss coaxial cable – 950630
  • Note:
    Optional cable lengths are available at checkout!
  • Installation hardware such as U-bolt and clamps (mounting pole, not included)

home-sized
pdfDownload Install Guide
pdfDownload Specification

Product Specification

Manual
 Installation and Instruction
Part Number
472205
Frequency
 824-894 MHz / 1850-1990 MHz
Gain
 65 dB / 65 dB
Max Output Power
 2.5 watts
Max RF (up/down)
 34 dBm / 15.7 dBm
Noise Figure
 3.5 dB nominal
Flatness
 ±5 dB
Isolation
 > 90 dB
Power Requirements
120-240 V AC, 50-60 Hz, 8 W max
Connectors
 F-Female
Dimensions
 6.2 x 4.2 x 1.5 (inch)
15.7 x 10.7 x 3.8 (cm)
Weight
 0.64 lbs / 0.29 kg

 

This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approv3ed antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards.

Leave a Reply